Moog Please Fix Envelope Sync / Loop Issue.
Posted: Sun Jun 23, 2019 9:40 pm
Basically, there is no way to set MIN values lower than 1/64th to either the Attack, Decay or Release when in Sync Mode. I believe this is terribly bad and here's why.
Say you want to create a simple 1/4 Loop but you don't want Attack or Release. You are forced to set Attack to 1/64 and Release at 1/64 (that's 1/32 of the 1/4 you're after). You would need to set Decay to 7/32 for the entire Loop to be exactly 1/4. Unfortunately you can't so you're left with either 1/8 or 1/4. So now your 'Synced' Loop is either 5/32 in length or 9/32 in length. You can't sync to another LFO, Sequencer, or Arp with those values. Guys, it doesn't ADD UP!
If you're following, great you understand the problem / if you're not, don't worry it shouldn't be this confusing and Moog should find a way to solve this so you don't have to think about it.
The simplest way to solve this (in theory) is to allow 0 values to Attack, Decay and Release.
Moog, can you please look into this? I mentioned it in one of the firmware update chat sessions and it never was mentioned again. The Sub 37 didn't have this issue and I feel like the Sync / Loop Mode on the Moog One is completely unusable like this.
Say you want to create a simple 1/4 Loop but you don't want Attack or Release. You are forced to set Attack to 1/64 and Release at 1/64 (that's 1/32 of the 1/4 you're after). You would need to set Decay to 7/32 for the entire Loop to be exactly 1/4. Unfortunately you can't so you're left with either 1/8 or 1/4. So now your 'Synced' Loop is either 5/32 in length or 9/32 in length. You can't sync to another LFO, Sequencer, or Arp with those values. Guys, it doesn't ADD UP!
If you're following, great you understand the problem / if you're not, don't worry it shouldn't be this confusing and Moog should find a way to solve this so you don't have to think about it.
The simplest way to solve this (in theory) is to allow 0 values to Attack, Decay and Release.
Moog, can you please look into this? I mentioned it in one of the firmware update chat sessions and it never was mentioned again. The Sub 37 didn't have this issue and I feel like the Sync / Loop Mode on the Moog One is completely unusable like this.