Subsequent Activate Panel

Everything Sub.
Post Reply
Jibba
Posts: 1
Joined: Thu May 26, 2022 8:08 pm

Subsequent Activate Panel

Post by Jibba » Thu May 26, 2022 8:14 pm

When I engage the activate panel my volume shoots way down, and when I engage the presets its very very loud. Is this common? Is it a firmware issue?

User avatar
RobustAmerican
Posts: 49
Joined: Tue Jun 04, 2019 10:52 pm
Contact:

Re: Subsequent Activate Panel

Post by RobustAmerican » Fri May 27, 2022 4:49 pm

Panel mode reverts to using the current positions of the knobs and buttons. (What you see is what you will hear) When I use panel mode, I almost always have to make a few adjustments just to get things at a nice working level.

For example: If the filter cutoff knob is at a low setting you won't hear much and the volume will most likely be low. If the envelope sustain knobs are set to a low setting, again you probably won't have much volume. Same goes for the oscillator levels.

Post Reply