Moog Music Forum

This is potentially a calibration issue of the Voyager's analog board. There is a trimmer to adjust the "output" of the noise on the board, and if this "output" is turned up too high it can cause strange artifacts and glitches in the Voyager's output, LFO, etc.

If you are experiencing this issue, please contact us directly for assistance and/or a calibration guide:

Adam Pryor
‪[email protected]‬‬
(828) 251-0090 Ext. 246

Harrison Street
‪[email protected]‬‬
Ext. 221

Noah Jolly
‪[email protected]‬‬
Ext. 204

Thank you,

Taylor Mott
Service Manager
‪[email protected]‬‬
Ext. 217

I might have this same problem.
I contacted Moog support a bit over week ago but never got a reply back from them.