RME Newbie with a question

jyoung · Post by **jyoung** » Tue Mar 10, 2009 11:01 pm

My new RME came with OS version 3.4. Isn't there supposed to be 7 banks of patches? If so, how do I switch from bank A to the other banks?

The manual was written for OS version 2.x and does not address patch bank switching and I could not find anything in the addendum about it.

Thanks

EricK · Post by **EricK** » Tue Mar 10, 2009 11:11 pm

I think theres a manual addendum here:
http://www.moogmusic.com/voyager/?secti ... uct_id=161

Try to hold the cursor button down while hitting the up or down arrow.

Also there are ALOT of articles addressing some of the most Frequently Asked Questions for all of the Moog gear:

http://launch.groups.yahoo.com/group/KnobTweak/

you woudl be wise to check those out.

Congradulations on your purchase and let us know how that thing works for you.

Eric

jyoung · Post by **jyoung** » Tue Mar 10, 2009 11:58 pm

Try to hold the cursor button down while hitting the up or down arrow.

Thanks! That was the ticket.

The RME came with the addendum but it was not clear to me how to change banks. I'll check out the KnobTweak forum too.

This is my first analog synth, so it quite a different beast than my Virus TI. Along with the RME I purchased an new audio interface with excellent pre-amps so that I could take full advantage of the analog. Working with a monophonic is the really new part, but the quality of the bass and leads is excellent so far.

EricK · Post by **EricK** » Wed Mar 11, 2009 12:07 am

Nice!

Hey not a bad choise for your first analogue!

Voltor07 · Post by **Voltor07** » Wed Mar 11, 2009 12:11 am

Can't go wrong with a Moog, that's for sure!