There's also a pot inside that you can mess with assuming you have an oscope or similar if you wanted something other than 1V per octave. I'm not an engineer but am guessing that the factory tunes the 351 pot to match the incoming voltage.theglyph wrote:Another nice thing about the 351 is that the KB CV out is V/oct! Therefore you can use your OS's KB to control you V/oct oscillators in your modular.
One of the guys in the support department mailed me a pot/resister combo to replace the pot on the analog board of the OS so I would have better luck when trying to match my LP's CV out. I haven't had to mess with it; no issues so far.
-Mike W. from NJ