Moog Music Forum

Share Ideas and Pass the word

Model D reissue pitch bend range via Sysex

Tips and techniques for Minimoog Analog Synthesizers

Model D reissue pitch bend range via Sysex

Postby davidrsimpson » Tue Oct 09, 2018 11:56 am

Hi,

I'm trying to change the pitch bend range of my Model D reissue via Sysex but I can't get it to take. Have I misunderstood this functionality? The Sysex I am sending is the following:

F0 04 15 00 14 05 00 0C F7

Any advice would be much appreciated!

Thanks.
davidrsimpson
 
Posts: 2
Joined: Tue Oct 09, 2018 11:48 am

Re: Model D reissue pitch bend range via Sysex

Postby Markyboard » Mon Oct 15, 2018 10:03 am

It looks like you're trying to set the pitch bend value to 12 decimal (0C Hex) which is the default. So no change. Try a different / lower value like 5 for example. Otherwise your message appears to be correct.

F0 04 15 00 14 05 00 05 F7
Markyboard
 
Posts: 95
Joined: Wed Jul 30, 2003 6:46 pm
Location: Springfield, VA

Re: Model D reissue pitch bend range via Sysex

Postby Minimooger » Sat Oct 20, 2018 5:47 am

davidrsimpson wrote:Hi,

I'm trying to change the pitch bend range of my Model D reissue via Sysex but I can't get it to take. Have I misunderstood this functionality? The Sysex I am sending is the following:

F0 04 15 00 14 05 00 0C F7

Any advice would be much appreciated!

Thanks.



Be aware that this affects only the MIDI pitchbend . It does not change the actual pitchbend on the minimoog undless you use that additional board.
Minimooger
 
Posts: 13
Joined: Thu Apr 27, 2017 4:31 pm

Re: Model D reissue pitch bend range via Sysex

Postby Markyboard » Sun Oct 21, 2018 7:00 am

Minimooger wrote:
Be aware that this affects only the MIDI pitchbend . It does not change the actual pitchbend on the minimoog undless you use that additional board.


I didn't realize this (I have the original only). But being a re-issue this makes sense.
Markyboard
 
Posts: 95
Joined: Wed Jul 30, 2003 6:46 pm
Location: Springfield, VA

Re: Model D reissue pitch bend range via Sysex

Postby davidrsimpson » Mon Oct 29, 2018 3:32 pm

Thanks guys, that's very helpful.
davidrsimpson
 
Posts: 2
Joined: Tue Oct 09, 2018 11:48 am


Return to Minimoog Forum

Who is online

Users browsing this forum: CommonCrawl [Bot] and 1 guest