Hello! I apologize if there is already a thread addressing this issue (I couldn't find it).
I have two Voyager RMEs. One works great, the other does too except I have been noticing that I cannot get the release of my waveform to last for than a second or so.
The A, D, and S all seem to work, and so does the R, it's just that its "range" is very limited compared to my other Voyager.
I did a side by side with Init. patches and the difference is very noticeable.
The oddest thing is that when I load a preset with a long decay, it plays out just fine.
This is what leads my to believe that it is a software thing (I haven't updated the OS since 2007).
Am I totally screwed? Am I missing a setting somewhere?
Anyone else experience something similar?
Thanks
Voyager RME release envelope seems "short"
-
- Posts: 2
- Joined: Sat Aug 06, 2016 3:29 am
Re: Voyager RME release envelope seems "short"
Try changing the Release Function in PANEL mode. This works just like the RELEASE switch in the LHC panel on the Voyager keyboard - this should adjust the release time.
EDIT: After making the change you may have to save each preset indivdually, as I don't believe the Release Function is global.
EDIT: After making the change you may have to save each preset indivdually, as I don't believe the Release Function is global.
-
- Posts: 2
- Joined: Sat Aug 06, 2016 3:29 am
Re: Voyager RME release envelope seems "short"
thank you so much! what a nice message to wake up to