Mod wheel out on back wrong impedance

Mother-32, DFAM, Subharmonicon, Grandmother, Matriarch
Post Reply
andy-cytomic
Posts: 2
Joined: Wed Mar 10, 2021 12:08 am

Mod wheel out on back wrong impedance

Post by andy-cytomic » Fri Jun 17, 2022 8:16 am

I noticed the mod wheel output from the back of the synth cannot be used as one of the things connected to a mult to mix it along with any of the other modulation sources, eg the output of an attenuator, or the output of an LFO etc.

Anyone from Moog: is there a specific reason for this? Why make all the front panel mod sources have the same output impedance so they can be mixed with a passive mult but then not also match the mod wheel output at the back to this same level?

User avatar
MRNUTTY
Posts: 319
Joined: Fri May 02, 2014 2:54 pm

Re: Mod wheel out on back wrong impedance

Post by MRNUTTY » Mon Jun 20, 2022 7:11 am

not that it needs saying to an impedance complainer :0) but you could make a patch cable with a 1k series resistor.

btw which synth is this for?
VoyagerEB, Minitaur, LittlePhattyII, 4xSlimPhatty, Sub37, MF[2x101,2x102,103,104M,105,105B,105M,2x107,108M], 3xCP251, XV351, MP201;
2xMother 32, DFAM, Subharmonicon;
System 55 and Minimoog clones with lots of mods.

Post Reply