Matriarch Oscillator rates changed after switch off/on

Mother-32, DFAM, Subharmonicon, Grandmother, Matriarch
Post Reply
longshot356
Posts: 1
Joined: Thu Mar 24, 2022 8:36 am

Matriarch Oscillator rates changed after switch off/on

Post by longshot356 » Thu Mar 24, 2022 8:44 am

Here's a strange one. If I switch my Matriarch off and on again a whole lot of rates have changed. Specifically...

Modulation (now v high)
Delay time (now v high)
Oscillators 2-4 (all now about an octave lower than before)

There may be other changes (perhaps filter spacing) but I'm less sure about these.

I can reset them by turn the knobs right down then back up to the desired setting but this is a pain, particularly as I'm v particular about my oscillators all being precisely in tune,

Problem seems to have started after midi syncing to other kit but remains now :? even after Matriarch completely isolated.

Does anybody have any idea what has caused this strange behaviour and how I can make my Matriarch well behaved again?

Post Reply