How can I adjust the Matriarch velocity curve with external modules?

Mother-32, DFAM, Subharmonicon, Grandmother, Matriarch
Post Reply
rgames
Posts: 4
Joined: Thu Jun 03, 2021 6:11 pm

How can I adjust the Matriarch velocity curve with external modules?

Post by rgames » Mon Jan 24, 2022 4:42 pm

I've discovered that my Matriarch goes very quickly from low velocity to high velocity, so I'm having trouble using velocity as a control because it's almost impossible to play it back repeatedly, especially on faster lines.

I found a few posts on the forum that say they have the same problem so I'm assuming it's a "feature" that's not going to change.

So my question is how I might be able to make use of the CV connectivity to adjust it? I know nothing about the modular world but I'm guessing there's some kind of module that would allow me apply some kind of input->output mapping to a CV signal. If I can do that then I think I can tame the quick transition with some kind of exponential curve.

Thanks,

rgames

Post Reply