Matriarch - Mixer and using CV

Mother-32, DFAM, Subharmonicon, Grandmother, Matriarch
Post Reply
Sebastiangarst
Posts: 15
Joined: Thu Dec 09, 2021 7:20 pm

Matriarch - Mixer and using CV

Post by Sebastiangarst » Tue Jan 11, 2022 12:04 pm

I read in the manual, and seen some videos about the mixer.

It says you can not only send audio to the mixer patch points, but also cv signals to control the signal.

I tried putting a triangle LFO - > osc 1 In. It kills the sound , i only hear sound if triangle LFO goes into audio rate..

How do i use the mixer inputs with cv ?

MaxFerency
Posts: 159
Joined: Tue Dec 15, 2015 12:16 pm
Location: Baltimore, MD, USA
Contact:

Re: Matriarch - Mixer and using CV

Post by MaxFerency » Sat Jan 15, 2022 7:28 pm

When you do that you are replacing the normal osc 1 signal w the LFO. I think want you want is take the osc 1 wave out and put that along w the LFO into one of the quads and then send that to the mixer for osc 1.
Max Ferency | http://maxferency.org | max [at] maxferency [dot] org
SYSTEM: macOS & Logic X Pro
GEAR: Matriarch, Sub 37, Korg SV-2, DFAM, MF Drive, MF Delay, MF Boost, Roland RC-202

Post Reply