Matriarch - MIDI not affecting some patch points
Posted: Mon Nov 23, 2020 11:23 am
Hi everybody,
I've noticed that my Matriarch responds inconsistently to the various types of control messages received from an external MIDI controller (in my case, my computer running Renoise). Here's what I've seen:
- Channel Aftertouch works great: it affects the KB AT OUT patch point as expected.
- Velocity doesn't do anything: it doesn't affect either KB VEL OUT or Arp/Seq VEL OUT (I've tried various global settings, including Arp/Seq CV Out Mirrors KB CV, and turning on/off Local Control).
- Mod Wheel (CC 1) affects the internally-routed connections from the Modulation section (Cutoff Amt, Pitch Amt, Pulse Width Amt), but does not affect the MOD WHL OUT patch point.
- CV OUT (on either front or rear panel) doesn't respond to the MIDI note. (Again, I've tried turning on and off Local Control and Arp/Seq CV Out Mirrors KB CV.)
Is this consistent with the behavior anyone else has seen? I know it could be an issue with my computer, software, or USB/MIDI interface, but the fact that Aftertouch works and Mod Wheel sort of works suggests that this is just how the Matriarch's firmware is configured. I've sent an email to Moog support to ask them, but haven't heard back yet.
Thanks!
-Ben
I've noticed that my Matriarch responds inconsistently to the various types of control messages received from an external MIDI controller (in my case, my computer running Renoise). Here's what I've seen:
- Channel Aftertouch works great: it affects the KB AT OUT patch point as expected.
- Velocity doesn't do anything: it doesn't affect either KB VEL OUT or Arp/Seq VEL OUT (I've tried various global settings, including Arp/Seq CV Out Mirrors KB CV, and turning on/off Local Control).
- Mod Wheel (CC 1) affects the internally-routed connections from the Modulation section (Cutoff Amt, Pitch Amt, Pulse Width Amt), but does not affect the MOD WHL OUT patch point.
- CV OUT (on either front or rear panel) doesn't respond to the MIDI note. (Again, I've tried turning on and off Local Control and Arp/Seq CV Out Mirrors KB CV.)
Is this consistent with the behavior anyone else has seen? I know it could be an issue with my computer, software, or USB/MIDI interface, but the fact that Aftertouch works and Mod Wheel sort of works suggests that this is just how the Matriarch's firmware is configured. I've sent an email to Moog support to ask them, but haven't heard back yet.
Thanks!
-Ben