sync M32 to DFAM

[aldred]

Hi

I can only find explanations of syncing the DFAM to M32. How can I use the DFAM clock as a master so I can utilise the new M32 clock divisions in 2.0?

Thanks

[mreid]

Patch the TRIGGER out from the DFAM into the TEMPO in of the Mother 32. Set the Tempo Input mode to Mode 3 – Analog Clock (i.e., use Shift + Reset/Accent + Set End + 8, use arrows to go to page 3 of the settings, press 3).

Hit Run on the DFAM and Run/Start on the Mother 32. The Mother 32 will be in sync with the DFAM. You can use the Tempo knob to control the clock multi/divisions on the Mother 32 relative to the DFAM.

[aldred]

Patch the TRIGGER out from the DFAM into the TEMPO in of the Mother 32. Set the Tempo Input mode to Mode 3 – Analog Clock (i.e., use Shift + Reset/Accent + Set End + 8, use arrows to go to page 3 of the settings, press 3).

Hit Run on the DFAM and Run/Start on the Mother 32. The Mother 32 will be in sync with the DFAM. You can use the Tempo knob to control the clock multi/divisions on the Mother 32 relative to the DFAM.

Thanks.
Mode 3 is "Din Sync Mode". Is that the same thing as "analogue clock"?

[mreid]

In the v2.0 firmware Mode 3 is Analog Clock mode. Prior to v2.0, Mode 3 was DIN sync mode. Check the v2.0 firmware PDF that came with the firmware download for details.

[bichuelo]

Patch the TRIGGER out from the DFAM into the TEMPO in of the Mother 32. Set the Tempo Input mode to Mode 3 – Analog Clock (i.e., use Shift + Reset/Accent + Set End + 8, use arrows to go to page 3 of the settings, press 3).

Hit Run on the DFAM and Run/Start on the Mother 32. The Mother 32 will be in sync with the DFAM. You can use the Tempo knob to control the clock multi/divisions on the Mother 32 relative to the DFAM.

Thanks.
Mode 3 is "Din Sync Mode". Is that the same thing as "analogue clock"?

DIN Sync refers to the clock which comes from the MIDI cable, so that won't work

[aldred]

In the v2.0 firmware Mode 3 is Analog Clock mode. Prior to v2.0, Mode 3 was DIN sync mode. Check the v2.0 firmware PDF that came with the firmware download for details.

Sorry, I missed that completely.
Thanks for the help.

[florencepugh]

You will need to connect the DFAM's "Gate Out" contexto jack to the M32's "Sync In" jack using a 1/8" TRS cable so as to use the DFAM clock as a master and sync the M32 to it.