How to connect Subsequent 37 CV with Mother-32 via CV connec

Mother-32, DFAM, Subharmonicon, Grandmother, Matriarch
Post Reply
Easy_Performer
Posts: 1
Joined: Thu Aug 01, 2019 5:14 pm

How to connect Subsequent 37 CV with Mother-32 via CV connec

Post by Easy_Performer » Thu Aug 01, 2019 5:35 pm

I need your help to control my M32 on my Subsequent 37CV via CV in order to use M32 as a 3rd osciallator on the other synth. Basically, I wanna do the following:

https://www.youtube.com/watch?v=OxBRxgqIEr0 :

However, I cannot trigger M32 on the Sub37 CV but I am only getting a crankling and regularly flapping noise of which the tempo could be changed by frequency knob of the M32. :? :? :?

Please see below my setup:
- M32 VCO1/Oct to Sub37CV CV Out1 (KB Pitch) using a TS 3,5/6.3 cable
- M32 VCA Mode is On
- M32 line out to Subs37 CV line in using a TRS 6.3/6.3 cable (or M32 GateIN to Sub37CV Gate Out1 (KB Gate) using a TS 3,5/6.3 cable // or M32's VCO Saw/VCO to Subseq37CV EXT in)
- Subsequent 37 CV Ext. in is turned on / Latch is on

I am under an impression that I should cablibrate the VCO on the M32 to get the Subseq 37CV tracking the M32 but it sounds a little bit complicated and I do not dare to jump into calibration.

I was also trying the pretty similar setup with an Arturia Keystep and it is working fine.

megadavid
Posts: 1
Joined: Sun Dec 06, 2020 5:58 pm

Re: How to connect Subsequent 37 CV with Mother-32 via CV connec

Post by megadavid » Sun Dec 06, 2020 6:11 pm

Hi E.P.,

your described setup seems to be the correct way to use the M32 as a third oscillator.

Perhaps we have (had?) the same problem because I can't get ANY cv-signal out of my subsequent 37cv. Have you been able to use the Sub37 cv-voltage/gate for any other purpose before?

cheers!

david

VirgilSynths
Posts: 1
Joined: Sun Sep 12, 2021 7:17 pm

Re: How to connect Subsequent 37 CV with Mother-32 via CV connec

Post by VirgilSynths » Sun Sep 12, 2021 7:20 pm

Anyone ever figure it out?

Post Reply