Page 1 of 1

Mother 32 pattern saving/recalling not working

Posted: Sun Sep 17, 2017 4:49 pm
by NickScottProducer
Hello.

I'm having an odd problem with my mother 32. I'll go to record a pattern on the sequencer while in keyboard mode. I'll save the pattern like normal, and for some reason (so far) ONLY patterns 1 and 2 work fine directly after saving a sequence, but when I switch from let's say pattern 1 to a different pattern then back to pattern 1 again, the sequence plays at half speed, doesn't start from note 1, and skips certain notes. I'm not too sure how this happened, but I believe it was by sending midi clock out via reaper. I'm really not sure, but I'd love to figure out how to at least successful save/play back a sequence on slots 1 and 2. Thanks so much!

Re: Mother 32 pattern saving/recalling not working

Posted: Mon Sep 18, 2017 1:10 pm
by SlowLFOtoPitch
While it could be because of your incoming MIDI, it is more likely due to the swing settings stored in that pattern. Try setting your swing back to center (hold shift while turning the tempo knob to center) and resaving the pattern.