Calibrate Werkstatt-01 with Beatstep

Everything Werkstatt.
Post Reply
painthing
Posts: 1
Joined: Wed Sep 28, 2022 2:32 pm

Calibrate Werkstatt-01 with Beatstep

Post by painthing » Wed Sep 28, 2022 2:44 pm

Could someone, please, answer -
Is it possible to calibrate Werkstatt-01 (w/ CV Expander)
with Arturia Beatstep's (not the pro version) pitch and gate outputs?
How to establish which C note and octave from Beatstep
is sending 0V to Werkstatt?

Thank you!

gr00veh0lmes
Posts: 5
Joined: Tue Aug 30, 2022 2:29 am

Re: Calibrate Werkstatt-01 with Beatstep

Post by gr00veh0lmes » Sun Jan 15, 2023 8:39 am

gr00veh0lmes wrote: Wed Sep 07, 2022 8:24 am The calibration procedure for the Werkstatt worked the same for the Mavis.

Note: This was done while Mavis was in an initialised setting (pitch knob at 12 o clock).

1. Determine 0 Volts on your controller, for my Keystep it was C-2. This can be confirmed by the pitch remaining constant while you adjust the Pitch Calibration screw.

2. Dial in the correct pitch (C in this case) using a tuner and the pitch control on the front panel.

3. Shift a few/several octaves up on your controller, play the same C and adjust the Pitch Calibration screw until the tuner shows a C.

You can confirm the above steps by playing C’s between those in steps 1 & 3 to finesse your results.

Video description here…
https://youtu.be/vVNI3jibZ4U

Post Reply