Page 1 of 1

Using with Voyager RME

PostPosted: Thu Dec 29, 2016 7:24 pm
by mrkeeny
Hi all,

I currently connect my RME to audio interface via balanced TRS lead.

I have purchased a minifooger delay and confused as to how I need to connect it all up.

Is it possible to incorporate the fooger while retaining the balanced connection?
Or, am I right in thinking that minifoogers only use unbalanced 'patch' leads ?

So, I will have to connect the output of the RME to the fooger with an unbalanced patch lead, and then connect the fooger to my audio interface using another patch lead?

Any advice appreciated as I can't seem to find anything definitive elsewhere.

Martin

Re: Using with Voyager RME

PostPosted: Thu Dec 29, 2016 9:30 pm
by bichuelo
I don't thing the RME has a balanced output. The ring is not connected anywhere inside its output jack. Check page 6 in the manual, it never speaks of a balanced output...

Re: Using with Voyager RME

PostPosted: Fri Dec 30, 2016 6:10 am
by mrkeeny
Hi, yes it does, on the RME only. See the switch in pic

http://medias.audiofanzine.com/images/n ... 453512.jpg