Animoog Pitch "wheel" not working
Animoog Pitch "wheel" not working
Nevermind. Figured this out too.
MF-102, MF-107, MF-m105, CP-251, MP-201, Elektron Octatrack, Filter Factory...
Re: Animoog Pitch "wheel" not working
You have to assign values to the pitch wheel in the Mod areas on the Env/Mod tab in Animoog. Try the following:
1. On the Setup tab, click on Mod-strips to enable the Modulation and Pitch Bend strips
2. On the Env/Mod tab, click on Mod 1
3. Leave source Off
4. Set Control to pitch-bend (and set the Amount knob below it to +100)
5. Set th Desitination to pitch-5-semitones.
6. Play a note and slide up and down on the Pitch Bend strip and have fun!
Hope this helps,
reidjazz
1. On the Setup tab, click on Mod-strips to enable the Modulation and Pitch Bend strips
2. On the Env/Mod tab, click on Mod 1
3. Leave source Off
4. Set Control to pitch-bend (and set the Amount knob below it to +100)
5. Set th Desitination to pitch-5-semitones.
6. Play a note and slide up and down on the Pitch Bend strip and have fun!
Hope this helps,
reidjazz