Just updated the firmware to 2.2.1
I was having the well documented stuck notes when I press stop on the hardware sequencer (303 clone)
This is fixed! Hurrah!
The other issue I'm having is when I change presets to audition a sound, it seems like the (non existant) mod wheel
is always at a value other than zero. This doesn't happen when I use it with an external keyboard / controller, so I'm
pretty sure it's not a value which is part of the preset.
The only workaround I have is to quickly grab the LFO - Pitch & mod knobs & turn them to zero.
Sound familiar to anyone else?
"Goofy" sounding presets when running w/ hardware sequencer
Re: "Goofy" sounding presets when running w/ hardware sequencer
Sorry I'm using a fairly early Minitaur SN 4670. I probably should have mentioned that...lol
- RobustAmerican
- Posts: 49
- Joined: Tue Jun 04, 2019 10:52 pm
- Contact:
Re: "Goofy" sounding presets when running w/ hardware sequencer
Maybe try using a midi monitor to see if something is getting sent to the Minitaur that isn't intended. (Cubendo has a free midi monitor built in as a midi insert) Most DAWS should have this built in but there are also free midi monitors available out there. Just search for "free midi monitor". Sounds like you already know this but the Minitaur can save the Modwheel position as part of a preset.
Good Luck!
Good Luck!
Re: "Goofy" sounding presets when running w/ hardware sequencer
Thanks!
Seems like it's the opposite, it happens when I'm midi'ed up to my Q Rack (no mod wheel)
& (nameless) 303 clone (no mod wheel) It doesn't happen when I send from logic, or my Kurzweil 2600 (Mod Wheel!)
Perhaps it's not getting a Modwheel = 0 message?
Seems like it's the opposite, it happens when I'm midi'ed up to my Q Rack (no mod wheel)
& (nameless) 303 clone (no mod wheel) It doesn't happen when I send from logic, or my Kurzweil 2600 (Mod Wheel!)
Perhaps it's not getting a Modwheel = 0 message?
Re: "Goofy" sounding presets when running w/ hardware sequencer
have you tried messing with the Load Preset Mod Wheel global setting? (setup tab of the editor)
I have never encountered the problem your describing and the way you're phrasing it suggest you've already tried that option but I'm curious. Sorry if this doesn't help.
(there is also a MIDI SysEx that can change that setting in case you don't have access to the editor).
I have never encountered the problem your describing and the way you're phrasing it suggest you've already tried that option but I'm curious. Sorry if this doesn't help.
(there is also a MIDI SysEx that can change that setting in case you don't have access to the editor).
Etherwave+ > Eurorack > [CV cables] > Minitaur , Sirin < [USB cables] < Bidule < nanoKontrols
Re: "Goofy" sounding presets when running w/ hardware sequencer
Thanks! I'll look into that...
Re: "Goofy" sounding presets when running w/ hardware sequencer
Fixed! Actually you need to turn "load modwheel position with preset" ON or it seems to load some presets with modwheel set to 127.
Thanks for the help folks!
Gotta say the LFO clock sync in a tight 303 type sequence sounds SPECTACULAR! For some reason this parameter seemed to
default to 1/2 note triplets so that was adding to the goofieness....
Thanks for the help folks!
Gotta say the LFO clock sync in a tight 303 type sequence sounds SPECTACULAR! For some reason this parameter seemed to
default to 1/2 note triplets so that was adding to the goofieness....