minitaur editor works in standalone, but wont work in protools

Welcome to the Taurus, Minitaur and Sirin Forum
Post Reply
TooMuchTuna
Posts: 1
Joined: Sat Mar 06, 2021 10:05 am

minitaur editor works in standalone, but wont work in protools

Post by TooMuchTuna » Sat Mar 06, 2021 10:08 am

Hi Folks,

My im controlling the minitour via usb from protools, and it receives midi just fine.

The standalone editor works if nothing else is open on my computer, but it isnt helpful.

i need the plugin to work in protools, but it says "the editor cannot connect to the hardware" "please connect your minitaur and set MIDI in and out on the setup page"

but it is connected, and the editor works in standalone.

how to i get it to work in protools?

im using the newest protools version on a pc.

User avatar
Montfrooij
Posts: 111
Joined: Sun Feb 02, 2020 4:12 pm
Location: Netherlands
Contact:

Re: minitaur editor works in standalone, but wont work in protools

Post by Montfrooij » Mon Mar 08, 2021 6:39 am

I had this a couple of times.
Turned out I did not install the windows driver.
https://www.moogmusic.com/downloads?type=46

Post Reply