Page 1 of 1

Minitaur Tuning

Posted: Sun Jul 28, 2019 7:19 am
by 9uile
I have a question about tuning my Minitaur.
After the warm up time (about 15min) i notice that i have to fine tune it. (turning the knob -15° approx)

I wish i could have the right tuning when the fine tuning knob stay at his center position.
I tried 'start calibration' with the Minitaur editor but nothing has changed.

Have you any advices to reach my goal ? (right tuning in the center position)

Re: Minitaur Tuning

Posted: Mon Aug 05, 2019 10:02 pm
by ummagumma
there may be a trimpot inside somewhere

but honestly that is why that external pot is there, and if it works, I would just leave it be

ps is there a heat source, or air conditioner near the minitaur? it may be picking up temp changes from something