Anyone else seen something like this?
Over the weekend, my Minitaur refused to boot. It went into a mode where all the lights flashed every few seconds.
Repeated power-cycle reboots, didn't clear the problem.
After an extended power down though (a few minutes), it was OK.
How much do I need to worry?
Minitaur not booting over the weekend, but it's OK now
Minitaur not booting over the weekend, but it's OK now
Voyager Performer, Minitaur
Cubase 8.5, Ableton 9, various hardware sequencers
OSX El Capitan on MacPro (cylinder) and MacBookPro.
Cubase 8.5, Ableton 9, various hardware sequencers
OSX El Capitan on MacPro (cylinder) and MacBookPro.
Re: Minitaur not booting over the weekend, but it's OK now
I had this problem again last night. Repeated power cycling didn't clear it.
Unplugged all connections for 5 minutes, then powered up OK.
This is looking like either poor connection somewhere, or a firmware issue along the lines of uninitialised variable / memory location.
Unplugged all connections for 5 minutes, then powered up OK.
This is looking like either poor connection somewhere, or a firmware issue along the lines of uninitialised variable / memory location.
Voyager Performer, Minitaur
Cubase 8.5, Ableton 9, various hardware sequencers
OSX El Capitan on MacPro (cylinder) and MacBookPro.
Cubase 8.5, Ableton 9, various hardware sequencers
OSX El Capitan on MacPro (cylinder) and MacBookPro.
Re: Minitaur not booting over the weekend, but it's OK now
In case it helps someone else, support are saying that this might be down to the ribbon connector to the front-panel being at fault.
Edit: The fault was - the power supply! All's well with a replacement.
Edit: The fault was - the power supply! All's well with a replacement.
Voyager Performer, Minitaur
Cubase 8.5, Ableton 9, various hardware sequencers
OSX El Capitan on MacPro (cylinder) and MacBookPro.
Cubase 8.5, Ableton 9, various hardware sequencers
OSX El Capitan on MacPro (cylinder) and MacBookPro.