Page 1 of 1
Minitaur range
Posted: Sun Apr 22, 2018 10:59 am
by Taurusrus
Looking at the -24 in global menu - is this as low as we go?
I can’t seem to get VCO 1 to the low octave (I.e the detuned -12 VCO 2 pitch)
Do I need a new controller with an octave down shift button or is it true with all these wonderful features that you can’t even get a low B.....?
Re: Minitaur range
Posted: Mon Apr 23, 2018 5:42 am
by umbrella
What kind of controller you are using?
(From Minitaur's specs: OSCILLATOR CALIBRATION RANGE: 22Hz-6.8KHz. Note range at 8’ = 0 - 72)
Re: Minitaur range
Posted: Mon Apr 23, 2018 3:48 pm
by MC
That interesting because the T3 can stretch into subaudio range over MIDI. We're talking below 20hz.
Re: Minitaur range
Posted: Mon May 07, 2018 10:40 pm
by EMwhite
MC wrote:That interesting because the T3 can stretch into subaudio range over MIDI. We're talking below 20hz.
Does it have something to do with the power supply on the T3? I remember hearing Steve talk about (or reading about) the lack of range in the MT being caused by the fact that the power supply is wall wart style with a minimalistic rectifier circuit on the Minitaur board meanwhile (I suppose) the T3 has more of a traditional power supply.
I don't know enough about electronics to know if this makes sense but you probably do.