Hello.
Just a question.
First of all, the DIN of my minitaur is used for a sync with an other musician, for this question I can only use the USB in/out of the minitaur.
I use Max/msp to send stuffs to the minitaur, so, only with usb.
It's working well.
The Minitaur react as it should, but not the editor.
When the editor is open in the same time,
only the hardware is responding.
But editor and minitaur are well connected eachothers.
For example, I have a footswitch sending CC to the minitaur, everything is working good with hardware but the editor doesn't react..
If I send a program change, the minitaur load the good preset but the editor not.
What is strange is that everything is working properly if I use the DIN : hardware AND editor are responding to my footswitch..
any idea ?
scuse my english =)
Ju
max/msp 7
firmware 2.1.14
editor 3.2.0b12.1
driver 3.30
W7 sp1 64bits