Moog Sub 37 ribbon cable question

In a Moog Mood? Here's a forum for discussion of general Moog topics.
Post Reply
mrkaplan
Posts: 1
Joined: Fri Jun 04, 2021 4:02 pm

Moog Sub 37 ribbon cable question

Post by mrkaplan » Fri Jun 04, 2021 4:06 pm

Hi,

Would anyone be willing to give me some advice on how to reconnect this cable? The connector broke off. I have attached a picture. Thanks in advance for all your help.

Jason
Attachments
CD794FB5-6D9C-4DD4-8885-E3829E60480C.jpeg
6F99A0AE-AC86-44F7-B1B1-9C6F9F31EC4C.jpeg

DigiGal
Posts: 3
Joined: Mon Jun 21, 2021 2:56 pm

Re: Moog Sub 37 ribbon cable question

Post by DigiGal » Fri Jun 25, 2021 9:53 am

It doesn’t necessarily look broken but cable pulled out of press fit crimp connection. Is there a cap/cover that went over it. If not I’d try carefully realigning it to the “v” piercing contacts and pressing down on the cable firmly to ensure contact with each wire inside it’s insulation.

If there is a cap/cover snap it back on to help keep the ribbon cable secure.
Moog Gear: Subsequent 37 | Werkstatt-01 w/CV Expansion Board | EP-3 Expression Pedal

DigiGal
Posts: 3
Joined: Mon Jun 21, 2021 2:56 pm

Re: Moog Sub 37 ribbon cable question

Post by DigiGal » Sat Jul 03, 2021 11:52 am

Did you have any luck Jason?

It seems like you should be able to purchase a replacement ribbon cable from Moog Support, recommend trying getting in touch with them.

[email protected]
Moog Gear: Subsequent 37 | Werkstatt-01 w/CV Expansion Board | EP-3 Expression Pedal

Post Reply