Page 1 of 1
MG1 Part needed
Posted: Wed May 04, 2016 2:45 pm
by electrojoe
Hello,
I am in need of the only un-obtainium part in the Moog MG1.
I am looking for a 100 ohm Tempco resistor.
One of them has gone out and the 1st oscillator will not stabilize.
Anyone have one, or know of a simple work around?
Thanks.
electrojoe
Re: MG1 Part needed
Posted: Thu May 05, 2016 6:25 pm
by Stevie Ray
Just wire in a 1% 100R carbon film resistor and see how it flies.
Re: MG1 Part needed
Posted: Fri May 06, 2016 2:13 pm
by stiiiiiiive
Hi electrojoe.
Out of curiosity, were you able to obtain a fader kit so far?...
Re: MG1 Part needed
Posted: Fri May 06, 2016 4:28 pm
by electrojoe
Thanks for the reply's,
I have tried a standard 100 ohm resistor, but the scale continues to change as the resistor can't adjust with the 3046 heat.
As for sliders,
This unit had the sliders replaced already.
Rather poorly, I had 2 issues due to poor installation.
I am pretty good at cleaning those, so that has not been a concern for me for a while.
Plus I have done a few replacement kits and have plenty of spares for broken shafts and resistor elements.
electrojoe.
Re: MG1 Part needed
Posted: Fri May 06, 2016 5:08 pm
by stiiiiiiive
Ok, thanks for answering and good luck for your quest
