Polymoog with no square wave output
-
- Posts: 25
- Joined: Sat Mar 19, 2011 11:54 pm
Polymoog with no square wave output
I've got a first generation Polymoog 203a, serial # 1979, with no square wave output. The sawtooth oscillator is functioning, however. The square waveform was working intermittently, but has now dropped out altogether. I've reseated the wire connectors, but the problem persists. I have the service manual, but figured I'd check in here to see if anyone can point me in the right direction. Any ideas?
Re: Polymoog with no square wave output
Is the top octave oscillator for the square wave emitting a signal?
Gear list: '04 Saturn Ion, John Deere X300 tractor, ganged set of seven reel mowers for 3 acres of lawn, herd of sheep for backup lawn mowers, two tiger cats for mouse population control Oh you meant MUSIC gear Oops I hit the 255 character limi
-
- Posts: 25
- Joined: Sat Mar 19, 2011 11:54 pm
Re: Polymoog with no square wave output
I haven't found the correct test points yet. This manual is spinning my head around. I've been focusing on the TL board..MC wrote:Is the top octave oscillator for the square wave emitting a signal?