Hi! I’m sure this information is availbe somewhere on the net, if you know where, please smile and point me to it, but I didn’t find it, so I allow myself to ask you:
Is it possible to cotrol a modulation “destination” (e.g. filter) only with a “controller” (e.g. pressure)?
(I.e. e.g. the aftertuch controls the filter cutoff with no other modulation going.) Judging from pictures of the modulation busses it may seem like a “source” always must be prestent.
Thanks
Yes, you simply have the Source as “ON” so on MOD BUS 2, it’s all the way to the right, then Dest is “Filter”, then Controller is “Pressure”
If I understood your question, that ought to do it.
In practice, when you apply aftertouch/pressure the filter cutoff decreases from the Filter Cutoff pot (say from 1K) downward when you press harder.
Ok, good. Thanks for your answer!
Oh and one other thing. If you WANTED to control it from outside of the Old School, (ie sync’ed to Midi Clk) you can use a MultiPedal LFO synced by Midi then send CV into the same MOD2 jack (using the settings as sighted above) on the back of the Old School.