[MTR][SPH] Please list historical, known MTR/SPH issues

[GilW]

@bichuelo

[MTR] I have a weird behavior of the CV mappings, for several versions, although I can’t be sure in which version it worked correctly.

Any parameter I map to the inputs, works perfectly well when I plug an EP-3 to it, even if I pass through the CV mixer and attenuator of the CP-251. But if I try to send a CV control from another moogerfooger or the CP-251 it does not work, whether I send 0-5V or -5 to +5V.
When there is something plugged, it sends the parameter to its maximum value then goes back to zero when I plug it out. This happens on every attenuator position.

Furthermore, when the parameter assigned is VCO 2 Pitch, the range has an offset when I send powered signals and I am not able to go past the middle position on the knob. But if I plug the EP-3, it works fine.

I am using firmware 2.1.7

Hi. Amos has checked into this, please see his following feedback:

“I confirmed using CP-251 that the Minitaur responds correctly to CV from a voltage source, and also from an expression pedal.
I observed that the pitch-CV input if calibrated correctly for pitch, might not reach maximum parameter value (for CV-mapped parameter) at maximum input voltage, and fixed this. pitch-CV input now goes to maximum when mapped to non-default parameters. (v2.1.16)”