My slim today when I plunged it a Cv/gate cables just died.
Screen has no text and is just white, the controls don’t change when I turn them and none of the buttons work.
Holding the master button while turning on the unit dosn’t load the debug so I can’t load the firmware.
Is there any think I could do ?
Thanks
You’ll probably have better luck directing your question to the Moog service department.
I have but no reply yer 
Give it a couple of days and I’m sure they’ll respond. Good luck and I hope you get it fixed ASAP!
I have opened it up, and have ordered a debugger, I just need to find out where I connect it to. I have seen it done to a little phatty but it’s a lot different in side.
Used the debugger with some institutions from moog and it’s all fixed now 
Cool!! Welcome back 
What did you have to do to your SP to get it up and running again? Sounds like a major challenge that I do not want to have to go through, but it would be nice to know anway!