previously filt slp
problem is reproducible
in editor
open new init preset
set pgm input to eg sine lof
set ppm output to eg filt alp
set mod source to f/pgm
set mod dest to f/pgm
observe slopes do not cycle
on sub 37
press mod controllers button
change pgm input to sine lao
observe slopes cycle
on return to editor
cycling maintained after initial manual setting
Hi,
I am now really a newbie.
We are talking about Sub?
What is sine lof.
What is filt alp
Can really not find this in the editor.
I am getting old.
Regards Luloop 
Sub 37
sine low freq osc
filter slope
sorry for typing errors
hI;
I can not reproduce this.
Maybe I do not understand you.
There are to many Typing errors.
I Really would like to try this out.
Regards Luloop
hopefully no typing errors
problem is reproducible
in editor
open new init preset
set mod pgm input to eg sine lfo
set mod ppm output to eg filt slp
set mod source to f eg/pgm
set mod dest to f eg/pgm
observe slopes do not cycle
on sub 37
press mod controllers button on affected mod
change pgm input to sine lfo
observe slopes cycle
on return to editor
cycling maintained after initial manual setting
mod 2 in attachment illustrates the setup
regards Iain
Hi,
I am sorry. Forgot to look to this.
Did all the steps.
Well I try it and did not find a real problem.
I press mode controller button on the Affected mod
change the pgm in SIne lfo.
return to the editor and listen but could not find any problem.
Running on X64 on the moment, course my mac is on the moment not available.
I am sorry
Wish you all the best.
Regards Luloop
Thanks Luloop,
Iain has just reported it works well for him too, on latest version.