Hello,
I would like feedback/help from others who are using parameter CC midi clips with their MF-108M.
The following will happen every time and almost straightaway when receiving MIDI CC messages.
The “BYPASS” is latching on and won’t allow manual control to bypass (switching off).
Once this happens all the front panel parameter controls cease operation and the unit lose’s its current parameter setting until the unit is powered down and then powered back on again.
I can’t find a definate procedure triggering it to happen (e.g. sometimes it happens within 30secs from firing a midi clip, sometimes 2mins, and sometimes straight away) I have spent most of the past 6 weeks trying to recreate the problem with different scenarios.
i.e. - with (licensed) Ableton Live8 suite active and not active
- with “BYPASS” on > then sending MIDI CC’s
- with “BYPASS” off > then sending MIDI CC’s
I have also swapped and used different MIDI cables and ports with other hardware (including the Voyager and MF-104M) that are operating correctly when receiving MIDI CC messages.
All of this has been tried with the original firmware the MF-108M had when I purchased it at the end of November 2012, as well as with the firmware v1.04 update.
…so yesterday I exchanged the unit at Awave for another MF-108M.
To my surprise this unit also is “crashing” during operation as described above.
I kept my modus operandi simple…
…Midi clip with CC parameter messages on CC# 12, CC# 13 and CC# 91, and after the unit crashed 4-5 times as above, I swapped the new exchanged MF-108M with my MF-104M Delay.
With nothing changed, I used the same project, midi clip, CC’s, midi interface/port (RME UC), midi cable, power supply, audio cables…
…the MF-104M Delay was rock solid even while changing many of the CC envelop parameters while the project was playing.
Has anyone else experienced this sort of problem???
Any shared helpful experience would be appreciated as this is starting to do my head in…
Cheers
