I’ve been looking around this forum and learning more about CV /Gate etc.
Someone on the forum mentioned that the ORB sends a 12V Gate signal. Will this hurt my Little Phatty, or just not work correctly?
At the moment I’ve got the Gate CV OUT going to Phatty Filter CV IN, which sounds great.
But, is there a better way to set this up?
I’m hopefully getting a CP-251 soon, should I revert back to MIDI control from the ORB until then?
moledog:
I’ve been looking around this forum and learning more about CV /Gate etc.
Someone on the forum mentioned that the ORB sends a 12V Gate signal. Will this hurt my Little Phatty, or just not work correctly?
At the moment I’ve got the Gate CV OUT going to Phatty Filter CV IN, which sounds great.
But, is there a better way to set this up?
I’m hopefully getting a CP-251 soon, should I revert back to MIDI control from the ORB until then?
you’ll need to attenuate the gate signal to +5v in order to make it work w/ the phatty, it won’t respond right w/ 12v. the cp-251 is exactly what the doctor ordered.
