Moog Music Forum

LFO sync is perfect here. I am using 2.2. The waveshape is perfectly synchronized to the beat.

Cubase doesn't show VST2 on the menu if it finds VST3 of the same plugin. For "hardware disconnected", did you select the minitaur ports in the preferences page of the Editor ? Also, connect the synth directly to the computer and not through a hub. It should really work.

Have you tried reinstalling the firmware ? It's possible that it didn't go through well the last time you did.

You have to turn On the Sync options for both Minitaur In and Out drivers in Ableton preferences. Then turn On MIDI SYNC in the editor. No need to use it as an external instrument anymore since v3.2.

I have a used LP which is in nice condition but it's pitch and mod wheel vinyl/rubber coating is very sticky. Looks like someone was trying to clean them with water and it just made things worse... Any trick to get those cleaned or less sticky ?

Thanks!

Hi, I was checking some of Voyager's presets and noticed that in some presets changing the settings of Osc2 Waveform, will change the overall pitch of the entire preset. I was wondering about how this is done and changed the settings of every single parameter to see when Osc2 Waveform stops affectin...

What a bummer ! I in some presets I must set the OSC levels to about 1 (of 10) to make them in balance with other "quiet" presets,
the sound I get when lowering the OSC levels is not similar to what I get when they are fully open....

Is the only way to set the volume for each preset is using the independent, each oscillator's level ?

Any way to set the final level for each preset, to the entire sound ?

Thanks!

Sure,

Thanks, I figured it out a few minutes after writing this post...
Best way would be placing the keyboard upside down, the spring side close to you.
Then gently forcing the spring side of the key down and pushing out from you on.

Should come out easily.

Hi all ! So I just got a few keys to replace some bad looking ones in my Voyager. I took the keyboard off but not quite sure how these Fatar keys can be taken off... Once I take of the spring holding the key, I don't see any way to take it out without having a lot of force applied, and I don't want ...

Thanks, It's a Little Phatty Stage II. I'm not sure I understand... If I use TS as Filter CV Input: Should the Sleeve be the negative lead and the Tip be positive lead, reading the range of -5v to +5v between the two ? My pedal shows only 0 to +5v when I use TS cable. If I use TRS as Filter CV Input...

Hi all, I'd like to control Filter CV using a pedal, but unsure as for what kind of input the Phatty's expects in the Filter CV Input... Should I connect a TRS plug into it ? or plain mono ? I have a Korg MS-01 clone pedal (-4v to +4v ) and also not sure if the out is TRS or mono... If I connect a m...

Thanks,

So if I wish to do this using a pedal, this should be a MIDI pedal which is able to simulate taps on the LFO button ?

Thanks, so basically this can only be done by MIDI In, correct ? I have another question though... I got a Korg MS-01 pedal DIY copy, which generates -4v to +4v Will this fit as input to the Phatty's CV IN ? I'm a bit confused as I think I read the Phatty CV goes 0 to +5v, but then the Moog MP-201 p...

Is it possible to send tap tempo to a Phatty ? and cannot be done NOT using the MIDI IN port ? (I use MIDI In for remote program change)

Thanks