Moog Music Forum

Maybe I should just get another phatty.. Ill check with my local dealer and see if I can rent a phatty until the minitaur is out or something.. I suppose Id rather loose a few bucks than buying the wrong synth. I can even buy one and resell it. Hmm.. Yes. This is good thinking.. Definitely on to som...

Ive just gone through every possible youtube video on the subject.., buuuuuuuut, I dont know.. Nothing quite sounds like a moog. Its when you have a little bit of release on the deep kicks and get a "bassline-kick" going.. lots off resonance in the lower register.. OH MAMA! I need it to be...

Wow.. Thanks.
Macbeth sounds really good!!!

Very expensive though.. If I only had the money.

I need a second synth to accompany my slim phatty. A small desktop (or modular) mostly for kicks/bass.. The minitaur would be perfect, but not sure if I can wait that long.. I LOVE the moog sound!!!!.., starting to think maybe nothing else will do.. I regards of sound, what are my best options?? :?:

ebo wrote:midi control for all parameters

I dont own a 103, but wouldnt an lfo plugged into rate just control the rate of the rate-knob moving up and down...?
Try sweep instead maybe..

Ahh.. Thanks.
I knew Id read about this somewhere...

Thanks..

Re-routed my whole setup today..

Freq volume output at 50%.
Interface input level in the yellow-zone..

No clipping.
Works perfect..
All good...

Im using an mp201(midi-to-cv) to control the filter on my Slim phatty..
OK to use bipolar voltage?

ColorForm2113 wrote:prevent the freq from peaking and clipping your interface

So there is no real danger of damaging any gear?
Just a clipping-issue??

- Is it safe to treat the OSC CV output as a normal audio signal, and send it to a normal input on a normal audio interface?
It doesnt burn up the input after a few weeks or something???

- Is the signal identical to the audio output pre-VCA..?

Doesnt sound like a big issue to me. But annoying, yes..
For the record, my dial knob works fine.

Thanks a lot. Ive completely lost objectivity on this stuff, so I appreciate your kind words.

Though I`d show what this stuff looks like in action..
Its basically just me practising.
Nothing planned or rehearsed upfront.

http://www.youtube.com/watch?v=5kd1GJZ8VfA

Oh man, those are beautiful. But discontinued.. crap.
Any other alternatives? (as short as possible)

But does any ribbon controller actually have a "zero-volt-center" with pitch both up and down on the same ribbon?