Moog Music Forum

I had this exact same problem. I sent the Voyager to Source distribution who are official Moog UK service centre. It took many months to diagnose and fix. Mainly because the fault was intermittent and could take days or weeks to show up. Firstly they replaced the power regulator and reflowed the sol...

On your audio interface make sure the inputs are set to line level and not mic or instrument.

I had a similar issue with my Voyager RME. It turned out to be the psu. The psu still wasn’t working correctly after having some parts replaced and all soldering redone so it got completely replaced with a new one. Took Moog repair centre several months to diagnose and fix..

If you have the cash Cirklon is good.
Also check out the Squarp Pyramid.

The RME may not have an X,Y pad built in but it certainly has the settings Rudi describes for X,Y pad. Inputs/outputs for the pad are on the CV expanders (VX351 and VX352). This is so that you can control the RME from another Voyager or CV source of your choice.

Yes.
Here's a video of how to connect the SQ1. https://www.youtube.com/watch?v=YyiFyqj09FQ
With SQ64 you can use CV/ gate or MIDI to sequence the Voyager.
Mono Machine and most other Elektron gear can sequence external instruments using MIDI.

andybutler wrote: ↑Fri Apr 23, 2021 5:17 am Depends on your DAW.
If it's Ableton then no chance.
"Rock solid midi" is a thing, but it just means "not like Ableton".

With Ableton there is every chance if you use Expert Sleepers devices instead of standard MIDI interfaces

If the pot mapping amount is set to something other than zero then velocity should be having an effect.

My advice would be "use your ears" because the knob positions won't line up.
Sometimes using visualisation helps, like oscilloscope, frequency analyser or recording into your daw or audio editor and comparing waveforms.

You get the Minituar template for Lemur from the Lemur website. To use it open it in Lemur, set you're MIDI connections and then touch the controls on screen.

Do you have a different MIDI interface to try with ?

Normally you use the knob on the side of the EP3 for calibration. Try a different cable.
Have you checked the settings on the Impulse 61 ? Most novation controllers let you set min and max values for pedal input.

I'd keep them all for synths.

Did you try contacting the uk distributer ?

You get an ios midi interface for the iphone and connect you’re controllers to it.
There are midi interfaces and combined midi + audio interfaces available.