Moog Music Forum

You may benefit from a dedicated midi controller, and yes, a better understanding of midi would make it quite a bit easier. In the yamaha manual there should be a section explaining how the synth uses which midi messages.

i'd be using it with guitar. so......what other LFO would i have to plug in to the input to get dual phasing? examples? You could buy a ringmod to use as an LFO, it has both an LFO, and another ocsillator, capable producing of low frequencies, which can be modulated by the LFO, also it is a ringmod...

I played a voyager at a store once the pitch wheel on that was much stiffer than on the phatty. It almost felt too stiff, but I must leave. . .

+1 for 107 mod, possibly with a gate on the osc out too. I don't have a 101, so I did not vote.

Hello moogers, I am curious as to whether it is possible to use the gate/trigger input to sustain a note, then also to trigger the envelopes while sustaining the note. So, I suppose my question is, can the trigger be used independently of the gate, while open? Are they located on different points of...

The main board is attached to the underside of the panel, and there is another one with all the jacks, maybe one with the power supply. Theoretically, it should be as simple as remounting the panel, and jacks in another box, without the keyboard installed, unless the keyboard, for some reason, is ne...

Hello all,

I am curious as to whether anyone knows of a good program, similar to midi ox, or sysex librarian which runs on linux.

Thanks,

Jeepo

The Guitar Center near my house has a few stage editions for about $850, if you don't care about usb, and there's a guitar center near you, check it out. They have two on display, I really like going in there, and playing with both of them, then leaving after I have constructed a suitable drone, if ...

A mod to output the fm signal from the freqbox would be very useful, and fairly simple, judging by the block diagram I'm trying to figure out what you mean by this. If you are applying FM to the freqbox's osc then thatll be at the osc out, if you are wondering about the signal that's being applied ...

one thing i haven't mentioned is that i bought the LP second hand and it had a fault that the control knobs used to change by themselves. it turned out that the power supply needed a transistor which resolved the issue. not sure if that has something to do with it, but i certain the power unit and ...

Supply & Demand. Only so many Buchlas, Moog modulars, VCS3s, ARP 2500s out there... I daresay a IIIc purchased at whatever astronomical rate today will be worth an even more insane price in ten years. Given the world economy these days, maybe it makes more sense to buy one of these than stocks ...

Mine doesn't do that, I don't think, but that's the problem with perception.

From the manual "DISPLAY UNITS allows you to select the way data is displayed on the LCD. When OFF is selected, no data values are displayed in the LCD. When VOLTS is selected, data is displayed as a voltage level. The voltage range is displayed to two decimal places: from -5.00 to +5.00V (Bipo...

A mod to output the fm signal from the freqbox would be very useful, and fairly simple, judging by the block diagram

Using the Osc Out would require a VCA or gate or something, because the oscillator is running even when not being triggered, and therefor between notes the osc would still be going at a pitch determined by the frequency knob (then when you play another note the osc out signal follows the inputs pit...