Moog Music Forum

What this means is that the PSUs you are looking at are not going to work. They are unlikely to conform to ATX 2.0, and not only do they not have the ATX12V connector, but they max out at around 160W which is almost half of the minimum needed for a board (and CPU) like this. You are going to have t...

There is an option to disable the transports messages via the keystep "Midi control center" software. Maybe you can try that too.

Maybe if Moog would like to provide some schematics, i don't mind resolder a jumper or a switch to enable/disable this behaviour.

Nobody know what it is ?

The P4 connector is on the mother32 motherboard not on the outer case (you have to unscrew it to see it)

Hi,

does anyone know what is P4 rear connector for on the mother 32 ?


Thx

yes, this is one workaround.

Hello
As far as I know your only option is to change the syncing output on the key step (look at the jumpers on the back and set a combination for a mode other than midi)