Moog Music Forum

I've experienced the same crashes, which I expect is due to the changes made to the Metal gpu engine in iOS. Having read the developer notes on the changes, it's actually a really good thing moog will have to update to it as the new OpenCl based stuff may actually give more processing power back to ...

Hi Amos,

If there is any chance in joining the other beta testers I would love to help out

Regards,
Steven

I also just checked the sequencer I have in Euro and tried with first, the Intellijel Metropolis. If you look in the manual. This is 100% in spec with Moog's Sub Phatty requirements. Page 2: "3 - PITCH output jack The pitch control voltage (CV) is produced here. This would usually be patched to...

Another thing to say is in another thread its stated by a moog tech the max controllable value is 5v , but they will accept upto a 12v signal with no damage to the input. However, when you remove the cable, so no input at all the signal is locked up there until I turn the sub phatty off then back on...

...which all adhere to the 5v per octave standard... Is this the issue? AFAIK Moog products confirm to a 1v per octave spread (with many discussion threads about it being slightly greater or slightly less than 1v depending on the specific product). Seems like 5v would send the signal up to the high...

Even a 0v input ( I've tried minus attenuated too) it goes to the highest pitch and locks. The cv cable unpatched to anything else causes it too. All the CV sources are doing this. The roland SBX is specifically designed not to go above 5v too. So it's either hardware or firmware. I've tested with f...

Well, if the Moog guys read any of this forum I hope they see this as emailing the support team has been useless. Any kind of response would be helpful for a product within warranty and one that is definitely a premium product in it's market. Not just a dead end. This is the 3rd sub phatty I am on n...

I've been through the software and the manual now and there's no global calibration for CV with the Sub Phatty. Does anyone have any other ideas? Could it be a mis-calibration on the firmware update? The only other thing I can see is the option to re-run the initial calibration routines. I've also u...

Thanks Dan, I'll give that a try tonight.

Is this done from the software or can it also be accessed through the shift functions? I didn't see any indication of it in the manual hence the questions

Hi Guys, I've finally got round to making up cables to get CV in to the sub phatty from my eurorack system, gate / filter / kb etc all seem fine, however pitch CV seems to be a little weird. I've tried 3 sequencers ( MFB 03 , Intellijel Metropolis and the Makenoise Rene ) which all adhere to the 5v ...

Just off the phone to the shop it's going to go back again.. so no need for this. I think they are quite embarrassed by it, so want to have it sorted out.

No, I've already returned one to the shop within a 24 hour period and with such a large journey and previous experience working on synths I feel that this would be a simple case of aligning the board, it was just to see if anyone knew the order of assembly to get to it.

I've just picked up my second sub phatty in as many days, yesterday's had a inoperative key out of the box, so another 200 mile round trip I got one with all keys playable, however this one appears to have a sticking pitch bend. It looks quite obvious the assembly for the mod and pitch bend is sligh...