Moog Music Forum

I have the 2.1.0 firmware installed on my Minitaur. I have made a patch that uses the "EG Reset" mode for the envelope trigger, but the Minitaur seems to forget this when I switch it off an on again, reverting to "Legato On", as far as my ears can tell. The v3.0 editor thinks the Minitaur is still ...

also VCA volume is not sending out any midi data.

I find the manual a little confusing on this point - it seems you can set the output volume/headphone level with CC#7, and I believe it's stored with the patch data, but the front-panel knob is not supposed to send CC data.

From the Minitaur ...

Hi Amos,

I hadn't noticed the dead zones before, so I went back and tried it in previous versions of the firmware - it's the same in v2.0.0, v2.0.4, v2.0.21 and v2.0.25, so I don't think it's a new issue - I just wondered whether it was intentional/a side effect of the hardware/accidental.

There ...

One of my oscillators is also out of tune after the update to v2.0.25. I get unison around the 2 o'clock mark on the VCO 2 knob, and can go to +7 semitones when fully clockwise. Turning the knob anticlockwise, I am also able to go down to 1 octave and 5 semitones below the pitch of VCO 1 (further ...