Moog Music Forum

That won't do the job for the OP. You modulate the volume of wet signal while he wanted to modulate the send to the delay line, i.e. keeping he delay tails in the game even when nothing is sent. I do this with a bassline and can time the CV to capture the tales. I understand this is not everyone’s ...

What I do is modulate the ‘mix’ parameter. Not sure what gear you have to do this with. I use an elektron A4. This is one of my favorite techniques.

Yeah, it's 5###, that was my mistake. I opened it up and everything looks clean and legit on the inside. Not sure what I was expecting see. My best guess is that it's been around the block a few times and someone lost the original lock nut on a sweaty stage long long ago. I can only imagine that som...

My ring mod seems less robust/different than the four other foogers in my collection. The knobs don't have a firmness that's usually present on foogers. There's actually a bit of play in the knobs. The footswitch has a circular locknut opposed to the hex-nut on my other units. And the metal face isn...

When I sent in a synth for repair, even under warranty, I paid for shipping to Asheville, they paid to ship it back to me. Not sure if anything has changed. It sucks. But if you want to hand deliver it to North Carolina you can skip shipping fees all together. Admiditly, shipping was cheaper than I ...

If it doesn't end then that "Limited Edition" that made me jump on the boat was a "LIE" There you have it......... Limited to what? You're mad over marketing-speak. Limited edition could mean limited to people who can afford a $1500 synth. You're presenting this as if you were b...

No. I run a Minifooger delay and a 104m as sends from my mackie mixer without anything but 1/4 cables. No other nonsense

Well I tried running the knob calibration again and everything is working! I may have been trying to send the knob-sysex-calibration in bootloader mode when I tried to resolve this unsuccessfully before.

I have not figured out my issue yet. Haven't had the time to call support. If I do figure out my issue, I'll be sure to report back.

This is probably your computers latency. Check your buffer settings in ableton.

The new owner just registers it, and they get the email. Not necissary for you to unregister.

Source: just registered a 2nd hand minitaur last week.

I was thinking that the 107 wasn't that cool.....until I realized that it pairs up amazingly with a microbrute. Microbrute cv controlling the 107's frequency. Run that all through my minitaur for the filter or more oscillators. Plus the minitaurs assignable cv-inputs. It's a slick miniature modular;...

Thanks for the suggestion. I just tried the knob calibration routine and it did not fix my problem.

Any other ideas?

Looking at the standalone editor I get a visual representation of my knobs when I move them. I can see and hear that some of them are not matching up on a 1:1 basis. For instance my VCO 1 LVL & VCO 2 LVL only use about 50% of the physical knob-turn to show 100% of the turn on the editor. What I'...

I like to modulate the pitch of OSC 2, while hard-sync'd.