Moog Music Forum

Even at full volume, the output is much quieter than other synths. Though after speaking with Moog Support, they said outputs are about where they are meant to be. One of the points they made was that the stereo output is 6db quieter than mono. This is accurate. Unfortunate, but accurate. There stil...

Had a very similar situation when controlling M32 from a Subharmonicon through tempo input. Possible Solution: Firmware update V2.0 created a method by which to change the "clock divisions" access this parameter by holding down the KB and Step buttons while turning the tempo knob to change...

Tried TRS cables and there was no change. Like literally barely usable signal and the noise floor... Sub Phatty, noon is almost too loud, Mother 32 is just right. Matriarch, barely audible at the same position...Have tried several different patches and consistently very low output. Any other suggest...

Have you tried using a Y splitter cable? Not sure if the layout is entirely the same, but it works on the Sub Phatty. Just plug one side into the Pitch CV and one into the Gate CV input.

To anyone still interested in this combo, use patch cables to connect in the following locations: SQ-1 WERKSTATT CV OUT VCO EXP FM IN (J4) GATE OUT VCA CV IN (J1) Works using either A or B out for the SQ-1 and you can mix the two. Set the CV Range on the SQ-1 to 1V to begin, but you can use all of t...