Knob Values to External Controller on Program Change?
Posted: Sun May 01, 2011 7:32 pm
First post!
So I've got a question - I have a LP, and I currently use a BCR2000 for easier and more visual access to all of the virtual knobs/controls on the LP. Is it possible to have the LP send the value for each knob (LFO Rate, Glide Rate, Cutoff Freq, etc.) whenever I change patches on the LP? In other words, can I somehow configure my setup to where when I change patches on the LP, the lights on the knobs on my external controller snap to where they are supposed to be for the new patch? Thanks!
So I've got a question - I have a LP, and I currently use a BCR2000 for easier and more visual access to all of the virtual knobs/controls on the LP. Is it possible to have the LP send the value for each knob (LFO Rate, Glide Rate, Cutoff Freq, etc.) whenever I change patches on the LP? In other words, can I somehow configure my setup to where when I change patches on the LP, the lights on the knobs on my external controller snap to where they are supposed to be for the new patch? Thanks!