Filter Knob & LED Ring Issue?
Posted: Thu Apr 28, 2011 5:10 pm
Hello all - new SP owner here, but I am slightly confused by something and I am hoping to get some input from the board.
I understand that the knobs must sweep through the value before the LED ring and the knob are in sync, but that's not happening. If I select Cutoff and sweep the knob, the LED syncs with the knob turn once it reaches the proper value, but then the LED value starts to vastly exceed the knob value. Turning the knob from 0% to 50% increases the LED value to 100%. Additionally, the filter fully opens by the time the knob hits about 50% (again, at this point the LED ring indicates 100%, so that remains appropriate).
This only seems to happen with the Cutoff and Resonance. All other knob/button combos seems to sync up properly. Is there something I am not understanding or doing wrong? Is there a filter setting somewhere that causes the filter not to require a full knob turn to open fully?
Thanks in advance for any help!
I understand that the knobs must sweep through the value before the LED ring and the knob are in sync, but that's not happening. If I select Cutoff and sweep the knob, the LED syncs with the knob turn once it reaches the proper value, but then the LED value starts to vastly exceed the knob value. Turning the knob from 0% to 50% increases the LED value to 100%. Additionally, the filter fully opens by the time the knob hits about 50% (again, at this point the LED ring indicates 100%, so that remains appropriate).
This only seems to happen with the Cutoff and Resonance. All other knob/button combos seems to sync up properly. Is there something I am not understanding or doing wrong? Is there a filter setting somewhere that causes the filter not to require a full knob turn to open fully?
Thanks in advance for any help!