Theremini delay bug?

Share your theremin experience: tips, tricks, techniques, favorite theremin moments.
Post Reply
User avatar
Gordon Charlton
Posts: 84
Joined: Sat Sep 23, 2006 2:07 pm
Location: Croxley Green, UK
Contact:
Contact Gordon Charlton

Theremini delay bug?

Post by Gordon Charlton » Sun Sep 13, 2015 5:53 am

Is anyone else experiencing a bug where if the delay time is set too long the delay feedback is reset to zero?

(Specifically, any controller values over CC12=107 + CC44=47)
Check out my theremin videos on my youtube channel.
Top
User avatar
Gordon Charlton
Posts: 84
Joined: Sat Sep 23, 2006 2:07 pm
Location: Croxley Green, UK
Contact:
Contact Gordon Charlton

Re: Theremini delay bug?

Post by Gordon Charlton » Wed Sep 16, 2015 9:09 am

Also, the volume antenna generates 7bit CC values in the range 0-125, not 0-127.

(I have not looked at the 14bit values.)
Check out my theremin videos on my youtube channel.
Top
User avatar
Gordon Charlton
Posts: 84
Joined: Sat Sep 23, 2006 2:07 pm
Location: Croxley Green, UK
Contact:
Contact Gordon Charlton

Re: Theremini delay bug?

Post by Gordon Charlton » Sun Sep 20, 2015 12:18 pm

Also, setting Wave Scan Rate to negative (i.e. CC values <64) does not reverse the mapping to either the pitch antenna or the volume antenna. (i.e. CC22 and CC23 - Pitch Mod Scan Freq, Vol Mod Scan Freq.)

I should have called this thread Gordon's Theremini Bug Reports.
Check out my theremin videos on my youtube channel.
Top
Post Reply

Return to “Theremin Forum”