Moog Music Forum

My Sub Phatty Oscillator 1 Octave Knob is no longer responding. Was this determined to be a hardware or firmware problem? I am running firmware 2.03, I believe.

Sorry, I should have made it clear I was addressing JJJ s problem in 2015, missing every sixth note, not the original poster in 2012. My comment stands.

If every sixth key is missing anywhere you play on the keyboard, the problem is not the keyboard. You can find a service manual online that will help diagnose which voice is problematic. You can also disable the faulty voice card, once you determine which one it is. I recommend you take it in for se...

I have been able to control the Werkstatt with a Beatstep, Roland MPU-101 and Pittsburgh Modular MIDI3, both with and without the CV Expander. It does seem that the different gates can affect the Werkstatt output level, though.

I have had no success syncing the Arturia Modular to the outside world. Would also like to know if it can be done.

Try the following: Connect the Nord audio out to the Rogue audio in. Connect the Rogue audio out to your mixer. In the Rogue Contour Generator section, set VCA Mode switch to "bypass". In the Rogue Mixer section, set all sliders to minimum. Set Rogue filter emphasis slider to minimum. Set ...

I listened to several parts, but not the whole composition. There is a similarity here to some of my work. I like it. I have some works that took two years to complete, and also wondered if it was worth it. Answer: yes, because of the experience gained. I have some stuff on Soundcloud too, under use...

if you want the Voyager to control the envelopes, split the Voyager audio output and send to both your mixer and the MF-107 audio input. Set the 107 mix to full effect so only the internal osc is heard. Send the CV signal to the 107 freq input to control the osc frequency. The internal 107 VCA will ...

When running external sounds thru the Phatty, you must open the gate as described in the posts above, AND the VCA sustain level should be set to maximum.

I am working on a composition with the Werkstatt where I am playing the Werkstatt button-board, controlling the filter cutoff with a Moog 1120 footpedal controller and running it through an MF-104M Analog Delay. This is No Toy! It may be limited, but it sounds great and is quite playable.

My Roland MPU-101 MIDI to CV Convertor manual has A442 in "Mid" transposition at 2.75 V. MIDI note 48 is approximately 1 V. The MPU-101 will transpose up and down one octave. The maximum voltage range shown for MIDI notes 0-127 is -3 V to +7 V.

The Rogue has a similar issue when using CV input. I use a signal processor (dotcom) to offset the CV signal and bring things back in tune.

The Werkstatt envelope is internal only, unless you modify the unit. I am using the Werkstatt with the Beatstep too. One solution is to use the Beatstep gate to trigger an external Envelope Generator (EG) and route the EG output to the Werkstatt VCA in. I am also using a Sub Phatty to do this, by ro...

Yes. There is a video at Sweetwater that shows how to connect external gear. I plan on connecting an Arturia Beatstep to my Werkstatt-01 using his recommendation for grounding. I just got my Werkstatt today (still un-assembled), but I have to finish waxing my car before I can have fun. I'm just on b...

Have you tried deleting any Sub Phatty objects in Audio MIDI Setup utility? I would delete any I find and then plug the Sub Phatty back in via USB.