That's what I am doing right now to get around this, but I would have definitely preferred that the mix knob worked in that way - even at 0% mix, the HF is rolled off on the original signal.jeepo wrote: You could use a mixer to mix the freq box into your clean signal
Search found 6 matches
- Wed May 04, 2011 4:25 pm
- Forum: Moogerfooger Forum
- Topic: Moogerfooger rolling off high-end of incoming signals
- Replies: 10
- Views: 4718
Re: Moogerfooger rolling off high-end of incoming signals
- Fri Apr 29, 2011 10:48 am
- Forum: Little Phatty & Slim Phatty Forum
- Topic: Filter Knob & LED Ring Issue?
- Replies: 4
- Views: 1614
Re: Filter Knob & LED Ring Issue?
Wow, okay so I completely blanked on the Local setting. The weird thing is this: only the cutoff and resonance seem to be impacted by the local setting being on. Some kind of weird midi feedback is happening and causing the knob to freak out, but only that 1 knob. I need to get into Logic's environm...
- Thu Apr 28, 2011 11:12 pm
- Forum: Moogerfooger Forum
- Topic: Moogerfooger rolling off high-end of incoming signals
- Replies: 10
- Views: 4718
Re: Moogerfooger rolling off high-end of incoming signals
I just brought home a Freq Box and this is definitely happening to me as well. I like this box, but I do wish it didn't roll off the high end like this. I find this thing works great with short, bright synth sounds, and I would love to just layer a little bit of the Freq Box grit under and otherwise...
- Thu Apr 28, 2011 11:07 pm
- Forum: Little Phatty & Slim Phatty Forum
- Topic: Filter Knob & LED Ring Issue?
- Replies: 4
- Views: 1614
Re: Filter Knob & LED Ring Issue?
Never mind - it's definitely busted. I've been experimenting with all of the knob modes, and the only one that works reliably is Snap. Both Track and Pass Thru are behaving erratically, and Pass Thru barely works at all. So it's back to the factory for this unit
- Thu Apr 28, 2011 5:10 pm
- Forum: Little Phatty & Slim Phatty Forum
- Topic: Filter Knob & LED Ring Issue?
- Replies: 4
- Views: 1614
Filter Knob & LED Ring Issue?
Hello all - new SP owner here, but I am slightly confused by something and I am hoping to get some input from the board. I understand that the knobs must sweep through the value before the LED ring and the knob are in sync, but that's not happening. If I select Cutoff and sweep the knob, the LED syn...
- Thu Apr 28, 2011 10:17 am
- Forum: Little Phatty & Slim Phatty Forum
- Topic: Filter Knob & LED Ring Issue?
- Replies: 0
- Views: 706
Filter Knob & LED Ring Issue?
Hi - new SP owner here, and I am not sure if I am doing something wrong or I have a bug in my unit. My filter knob seems to have an issue. When I switch to Cutoff or Res and sweep the knob, the LED's remains stationary until I sweep past the value - this is fine, and is the behavior I expect. Howeve...